23
Page
3. Crimp the
Fork terminals
to the cable.
(Fig. C)
4. Tighten the two
Fork terminals
beneath the two
Remote controller terminal
screws on the back of
the main body.
(Fig. D-1)
5. Cut out the inlet for the remote controller cable
from the bottom of the main body.
(Fig. D-2)
6. Place the
Main body
back on the
Back plate
, with
the
Remote controller cable
running out of the
bottom inlet.
Remote controller
terminals
Fig. D-1
Two fork terminals
Remote controller cable
Inlet for the remote
controller cable
Cut out
Fig. D-2
<How to connect the remote controller to the water heater>
1. Disconnect power supply from the water heater.
2. Take off the water heater’s front cover.
3. Locate the two terminals for the remote controller in the water heater. (Refer to the Fig. E-1 and E-2.)
4. Put the remote controller cable through the hole at the bottom of the casing of water heater from
outside.
5. Secure both terminals on the controller cable to the terminals in the cabinet as shown below.
(Secure them underneath the screw terminals. No polarity.) See Figures E-1 and E-2.
* Do NOT jump or short-circuit the wires, or the computer will be damaged.
6. Replace the water heater's front cover securely.
Installation
Installation Manual
Fig. E-1
110C and
310C models
100209924
(TM-RE42)
Connect other end to these terminals
510C model
100209924
(TM-RE42)
Connect other end to these terminals
Fig. E-2
Remote controller cable
1-3/8 Inch
(35 mm)
Fig. C
1-5/8 Inch
(41 mm)
Fork
Terminals
