22
Page
TEMPERATURE REMOTE CONTROLLER
-Optional item-
• The remote control is an optional accessory that can be installed in a hall, closet, etc., to allow for
temperature adjustment without having to go to the heater.
•
When installed, the remote will take priority over the built-in controller.
Verify that the items listed below are included with the remote controller
100209924 (TM-RE42)
.
Temperature
remote controller
Screws
Fork terminals
Manual
Qty: 1
Qty: 2
Qty: 4
Qty: 1
-Installation-
•
This remote controller is NOT waterproof.
•
The water heater can only have one remote controller.
•
Do not install in high temperature environments, high humidity conditions outdoors,
in direct sunlight, or within the reach of children.
•
Make sure the remote controller does not come into contact with water or oil.
WARNING
•
Do not place the remote controller cable close to other wires from other products.
•
Cables used for the remote controller connection must be:
•
Minimum 20
gauge wire (No polarity)
•
Maximum 400 ft (122 m) long
NOTICE
<Mounting and wiring the remote controller>
1. Take off the
Back plate
from the remote controller with a flat head screwdriver.
(Fig. A and B)
2. Attach the
Back plate
on the wall with the two provided screws.
(Fig. B)
Fig. B
Back plate
3-1/4 inches
(82.6 mm)
Attach the screws
Cut out the partition with pliers
Main body
Fig. A
Main body
Twist
Press and twist flat head
screwdriver against the cutout.
Installation
Installation Manual
