TAJIMA TFHX Series, User Manual

Page: 123 / 140

CHAPTER 12 MAINTENANCE
116
5. INSPECTION
6. REPAIR
WARNING
During machine inspection, turn off the primary power supply.
(Before turning off the primary power supply, turn OFF the
power switch.) You may sustain severe injuries due to being
entangled by moving machine units.
Inspection Point Contents of inspection Inspection Cycle
(1) Each belt of main shaft drive sys-
tem Tension of belt, degree of
wear, existence of crack
Once/3 months
(2) Each belt of X/Y drive system
Tension of belt, degree of
wear, existence of crack
(3) Rotating and sliding sections Degree of wear
WARNING
To prevent accidents resulting in injury or death and physical dam-
age, the following must be observed when performing the repairs of
the machine.
Before starting the work, be sure to disconnect the primary
power supply to the machine (Before disconnecting the primary
power supply, turn OFF the power switch.). Even if the primary
power supply is turned off, some circuits are still charged. Wait
(4 minutes) until these circuits are completely discharged and
then start the work.
If the machine needs repairs, the repairs must be done only by
the service personnel assigned and trained by Tajima or quali-
fied technician. (Consult your distributor.)
Do not change the specification nor modify the parts of the
machine without due consultation with Tajima. Such modifica-
tion may risk the operational safety.
When restarting the machine after repairs, attach all covers etc.
which were removed for repair operation.
CAUTION
For the machine repairs, use TAJIMA genuine parts for replace-
ment.
(GC02)
!
!
!