- 4 -
2.3 Terminal board
Use terminal board on the rear panel of the main unit for the connection between BK,
external receiver or decoder. Insert a connection wire in a terminal in the following ways.
Note: Use connection wire with single core 0.4~1.0mmØ or standard twist core
0.3mm
2
~0.7mm
2
.
2.4 Grounding
A GND terminal is on the rear panel of the main unit.
Be sure to ground the main unit using attached earth wire (3m KIV wire 50/0.45 with copper
tube terminal).
Insert a connection wire to a hole
while pressing the push knob
Push knob
Wire hole
Connection
wire
Press a push knob by
a screwdriver
Terminal board
Peel off vinyl sheath
of the wire about 10mm
Summary of Contents for TF-711
Page 33: ...Base Cabinet Outside view ...
