58
System Configuration
T801-4 Installation and Operation Manual
© Tait Electronics Limited September 2007
Connection
1.
Connect the Trimble Bullet III GPS antenna to the
GPS ANT
connector on the rear panel. Refer to
“Cabling” on page 79
for more
information on connectors and appropriate types and lengths of
cables.
2.
Connect the external GPS receiver to
PORT A
on the rear panel using
the supplied 30m cable.
Link Settings
There are no changes to the factory default settings.
Programming
Program the Satsync 7 module(s) as required for:
■
output frequencies
■
output levels
■
fault output delay.
Note
Do not change the timing source options for this configuration.
Leave both check boxes clear. If two Satsync 7 modules are fitted,
set the same fault output delay for each module.
Refer to
“Setting Up the Satsync 7 Module” on page 39
for more
information on programming.
Figure 4.4
Connecting the T801-4 to a GPS antenna and external GPS
receiver
Trimble Bullet III active antenna
T801-4 - rear view
Dalman 40742 GPS antenna/receiver
