Floppy Drive
The 2000I-DP is equipped with a standard 1.44MB Floppy Drive. Like the
SuperDisk, it uses standard 3.5” Floppy Disk media. To eject the floppy disk, press
the floppy eject button located on the right side of the drive. Do not eject the
media if the floppy drive activity light, located on the left side of the drive, is lit.
HDIT-108R
Front Panel - Hot-Swap RAID Hard Drives
The HDIT-108R is equipped with four hot-swap 18GB Ultra 2 Wide SCSI LVD
hard drives,
(See Figures 10 & 11)
.
TAG has configured the removable drives with
the following SCSI ID’s: The bottom left drive, Drive 1, is SCSI ID #0 and the top
left drive, Drive 2, is SCSI ID # 1 the bottom right drive, Drive 3, is SCSI ID #2 and
the top right drive, Drive 4, is SCSI ID # 3. Refer to page 10 for all SCSI IDs. In the
event that one drive should fail, simply remove it and replace it with a working
drive.
To remove either drive, insert the hard drive module key and turn the keylock to
the unlocked position. Grab the handle and slide the drive out. Insert the replace-
ment drive into the 2000I-DP and return the keylock to the locked position.
4
5
The 2000I-DP is equipped with an 48X E-IDE CD-ROM,
(See Figures 1 & 8)
.. To
load a CD, press the CD tray eject button. Place the CD on the CD tray, and press
the tray eject button again. The CD activity light will illuminate intermittently, as
the CD is read.
Front Panel - CD-ROM
Figure 13
Figure 10
Figure 11
Figure 8
