83
diagnostic messages
operating manual
‘no decoding’
‘no input data’
‘no input signal’
This message indicates that the AV32R has received data which it
cannot correctly decode. This is usually caused by a faulty digital
player or disc. The unit will mute should this occur. If the problem
persists, please report this to your retailer or the TAG McLaren Audio
Helpdesk, stating which digital player and disc you are using.
This message indicates that there has been no data present in the
selected digital input for more than 10 seconds.
This can occur:
• if there is no disc playing in your digital source player.
• if you try to play a DTS-encoded disc on a non-DTS
compatible DVD player
If neither of the above is the case, then you should contact your
retailer or the TAG McLaren Audio Helpdesk, stating which
digital player and disc you are using.
This message indicates that there is no digital data stream being
fed to the selected digital input.
This can occur:
• if no digital source is connected to the selected input (or the
player that is connected is switched off).
• when there is no disc in some DVD / LaserDisc players.
• when you pause, stop, skip forward or skip back on some
DVD / LaserDisc players
The unit will mute should this occur.
If none of the above is the case, then you should contact your
retailer or the TAG McLaren Audio Helpdesk, stating which
digital player and disc you are using.
GRR00892.01-AV32R OPER 3.7x 6/14/02 9:35 AM Page 83
