learning new
commands
To ‘learn’ new commands:
1. Select the device you wish to program by pressing the
appropriate
REMOTE SELECTION
key on the AV32R Remote.
2. Place the AV32R Remote and the remote of the unit you
want to control on a flat surface. Line up the remote controls
head to head, about 5 to 10cm (2 to 3in) apart.
3. Simultaneously press and hold the
REMOTE SELECTION
key
selected in step 1 and the
ok
key for about four seconds. The
learning status LED will turn yellow to indicate that the
Remote is now in learning mode
(1)
.
4. Press and release the key on the AV32R Remote which you
want to program
(2)
. The status LED will flash yellow.
5. Press and hold for approximately three seconds the key on
the original remote control which corresponds to the
function you want the AV32R Remote to learn. The status
LED will flash shortly in green if the code is correctly
understood. If it flashes red then you need to restart with
step 4 as the code was not understood by the remote.
6. Release the key on the original remote and re-press and
hold it for approximately a further three seconds. If the
learning process has been successful, the status LED will
flash green twice, then return to yellow. If the LED flashes
red you need to restart with step 4 as the code could not
correctly be interpreted by the remote.
programming the remote control
74
operating manual
cd
dvd
amp
av
R E M O T E S E L E C T I O N
sat
tv
vcr
ld
pause
play
skip
+
record
skip
eject
---
stop
ok
return
cancel
LFE
LFE
---
+
r
e
w
f
f
d
s
image
analog ------
dig ------
dig +
store
erase
station ------
functions
vcr
ld
tv
sat
R E M O T E S E L E C T I O N
cd
dvd
amp
av
1. The Remote will stay in learning mode for 20 seconds, after which it will return
to normal operation mode if there have been no further key presses
2. The macro keys
m1
to
m4
can be programmed with new commands, but if they
are used for the macro feature (see ‘programming macro features’) the new
command will be over-ridden
GRR00892.01-AV32R OPER 3.7x 6/14/02 9:35 AM Page 74
