Y-8
Y-8
Operation Check (Crane Operation)
46
WY05-4510E
7. Warning
[NOTICE]
For the location of the buzzers, refer to "Z-10 Electric Parts Location Diagram (Upper), 1. Inside cab ".
8. Outrigger slide plate adjustment
1. With the outriggers fully retracted, install the slide
plate and the plate into the outrigger box.
2. Adjust the slide plate with the bolts X so that the
slide plate is 1.5 mm (0.06 in) away from the
upper surface of outer outrigger box bottom plate.
3. If the slide plate is 1.5 mm (0.06 in) or more away,
make sure that the bolts X do not protrude beyond
the plane Z.
4. Tighten the bolt Y slightly to fix the slide plate.
Then tighten the nut of the bolt Y hard.
5. Tighten the nuts of the bolts X.
Item
Warning
buzzer
Sound
Checking procedure
AML limit
Buzzer
(CN818)
•
280Hz
•
Continuous
low tone
Buzzer sounds at 100% when main switch is ON and PTO
switch is ON. (Intermittent low tone sound occurs at 90% and
above.)
Two-blocking
warning
Buzzer
(CN817)
•
2300Hz
• Continuous
high-low tones
Buzzer sounds when the two-blocking detection switch
contact of either the main or auxiliary winch is turned OFF by
winch hoisting up operation.
Outrigger
operation switch
detection
Buzzer
(CN818)
•
620Hz
•
Intermittent
beeping
(high tone)
Buzzer sounds when either the outrigger extend/retract or
jack slide selector switch has been left in any position other
than neutral for 10 seconds or more after operation is
completed.
Outrigger
malfunction
warning
Buzzer
(CN818)
•
620Hz
•
Intermittent
beeping
(high tone)
Buzzer sounds when the wire is drawn out from the outrigger
length detector for 100 mm (3.94 in) or more with the
outrigger not being operated.
Summary of Contents for GR-500EXL-3
Page 1: ......
Page 8: ...7 WA04 4610E 6 Group index System Diagrams Data Adjustment and Checks Y Z Y Z...
Page 102: ...Z 7 Z 7 Hydraulic Parts Location Diagram Lower 31 WZ07 3950E 2 Steering 2 346 418 02000...
Page 108: ...37 WZ08 0590E Z 9 Z 9 Pneumatic Parts Location Diagram 3 Control parts lower 4 349 232 60000...
