Tabor Electronics Lucid LS1291B, User Manual

Page: 19 / 39

Lucid Series RF Signal Generator
Benchtop User Manual
Rev. 1.4
19
▪ Trigger – The device waits for an external trigger event.
⧫
LED –
▪
Gray – The output RF channel is off.
▪
Green – The output RF channel is on.
•
Frequency – Sets the generator’s basic frequency in Hz. You cannot enter a frequency smaller than
the minimum frequency. Refer to 4 Lucid Benchtop Specifications, page 34 for valid frequency
range.
•
Power – Sets the power (amplitude ) of the generator’s output signal (in dBm).
The default value is 5.00 dBm.
•
Phase Offset – Sets the phase offset of the signal. Phase offset range is between 0 degrees to 360
degrees .
The default value is 0 degrees.
3.2 Modulation Tab
The user can set the basic output parameters of the generator in the Modulation tab. The modulation
types that are available depends on the installed options.
3.2.1 AM – Amplitude Modulation
Figure 3.2 AM – Amplitude Modulation
•
Frequency – Set the modulation frequency (Hz/kHz).
•
Depth – Set the AM modulation in percent of the carrier wave amplitude.
•
Source – The Enter key of the front panel will toggle the values.
⧫
Internal – Use the screen modulation parameters.