T-Fal EASY FRY GRILL DIGITAL Manual Download Page 5

Page: 5 / 21

Note: If you want, you can also let the appliance preheat without any food inside. In
this case, turn the timer knob to more than 3 minutes and wait until the heating-up
light goes out (after approx. 3 minutes). Then fill the bowl and turn the timer knob to
the required cooking time (see Cooking Guide for timings).

•  The timer starts counting down the set cooking time.
•  The heating-up light goes on.
•   During the hot air frying process, the heating-up light goes on and off from time to time.

This indicates that the heating element is switched on and off to thermostatically maintain
the set temperature.

• Excess oil from the food is collected in the bottom of the bowl.
8. Some foods require shaking halfway through the cooking time (see section ‘Cooking

Guide’). To shake the food, pull the bowl out of the appliance by the handle and shake it.
Then slide the bowl back into the appliance.
Tip: You can set the timer to half of the cooking time, and when the timer sounds shake the
ingredients. Then set the timer again for the remaining cooking time.

9. When you hear the timer sound, the cooking time set has finished. Pull the bowl out of the

appliance and place it on a heat-resistant surface.
Note: You can also switch off the appliance manually. To do this, turn the timer control
knob to 0.

10. Check if the food is ready.

If the food is not ready yet, simply slide the bowl back into the appliance and set the timer
for a few extra minutes.

11. When the food is cooked, take out the bowl. To remove food, use a pair of tongs to lift the

food out of the bowl.

Caution

: When you turn the bowl, be careful of any excess oil collected at the bottom of the

bowl that may leak onto the food and of the grid may fall down.
After hot air frying, the bowl, the grid and the food are very hot. Depending on the type of
food cooked in the appliance, be careful as steam may escape from the bowl.

12. When a batch of food is ready, the appliance is instantly ready for preparing another batch

of food.

USING THE GRILL MODE

1.  Place the grill grid in the bowl of the appliance.
2.   Move the temperature control knob to the 200°C / 392°F.
3.   Turn the timer knob to 15 minutes. This will launch the preheating phase.
4.  When you hear the timer sound, the preheating phase has finished.
5.   Open the appliance and put the food in the grill plate.

Caution : the bowl and the grill

plate are very hot. Use a pair of tongs to place the food on the grill plate.

6. Select the required cooking time (see section ‘Cooking guide’.)
7. Put back the bowl on the appliance.

Cooking starts. The timer starts counting down the set cooking time.
Excess oil from the food is collected in the bottom of the bowl.

Note : the pieces of meat required to turn them at half cooking.

8. When you hear the timer sound, the cooking has finished. Take the bowl out the appliance

and place it on a heat-resistant surface.

9. Check if the food is ready. If the food is not ready yet, put it back on the appliance and set

the timer for a few extra minutes.

10. When the food is cooked, take out the bowl. To remove food, use a pair of tongs to lift the

food out the bowl.

COOKING GUIDE

The table below helps you to select the basic settings for the food you want to prepare.

Note: The cooking times below are only a guide and may vary according to the variety
and batch of potatoes used. For other foods the size, shape and brand may affect results.
Therefore, you may need to adjust the cooking time slightly.

Min-max

Amount (g)

Approx

Time (min)

Temperature

(°C / °F)

Shake*

Extra

information

Frozen chips (10 mm x

10 mm standard thickness)

300-800 g