机床产品
/Machine Tool Products
–
60CA/60CB Simple-Type Wood Cutting Machine Operation Manual
Fenu and System Introduction
–
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
i.
ii.
iii.
iv.
v.
vi.
•
•
•
•
•
5 Buttons: F2 Program
→
Next
→
F2 Block Copy
→
F2 End Line
8 Buttons: F2 Program
→
F5Block Copy
→
F2 End Line
Function
Define the end line of block.
Block Cut
Command
5 Buttons: F2 Program
→
Next
→
F2 Block Copy
→
F3 Block Cut
8 Buttons: F2 Program
→
F5Block Copy
→
F3 Block Cut
Function
Cut the block that had been selected.
Block Copy
Command
5 Buttons: F2 Program
→
Next
→
F2 Block Copy
→
F4 Block Copy
8 Buttons: F2 Program
→
F5Block Copy
→
F4 Block Copy
Function
Copy the block that had been selected.
Block Paste
Command
5 Buttons: F2 Program
→
Next
→
F2 Block Copy
→
F5 Block Paste
8 Buttons: F2 Program
→
F5Block Copy
→
F5 Block Paste
Function
Paste the block that had been
「
Block Cut
」
and
「
Block Copy
」
.
Operation Method
Move the cursor to the desire line and press
「
Start Line
」
and function key
「
End Line
」
enable.
Press
【
↑
】【
↓
】【
Page Up
】【
Page Down
】
to select desired area.
Press
「
End Line
」
,block between
「
Start Line
」
and
「
End Line
」
will be selected.
→
Function key
「
End Line
」
disable.
→
Function key
「
Block Copy
」
enable.
→
Function key
「
Block Cut
」
enable.
→
If
「
Block Cut
」
being use, the whole block that had been highlight will be cut off.
→
Function key
「
Block Copy
」
/
「
Block Cut
」
disable.
→
Function key
「
Block Paste
」
enable.
Move the cursor to the desire location and press
「
Block Paste
」
, the content that had been cut
or copy will paste at the cursor location.
If
「
Block Copy
」
is used, the block that had been selected will not disappear.
Note
If
「
Block Cut
」
is use, and do not paste the content immediately, the cut program will disappear.
The contents of
「
Block Cut
」
can be pasted for only one time but the contents of
「
Block Copy
」
can be pasted for many times.
