CIPHER 1022 User Manual
- 3 -
CODE 39 FULL ASCII, both CODE 39 and FULL ASCII must
be enabled.
2.3.2 Check Character Verifications
For the symbologies listed below, the use of check character
(digit) is optional. Check character (digit) verification could be
enabled or disabled for these types symbologies on CIPHER
1022.
•
Code 39
•
Code 39 Full ASCII
•
Industrial 25
•
Interleave 25
•
Matrix 25
•
CP 25
2.3.3 Check Character Transmission
When this option is programmed to be "DISABLE", the last
character (digit) will be omitted upon transmission.
2.3.4 Code Length Checking
For Industrial 25, Interleave 25, Matrix 25 and CP 25, a
minimum and maximum length ranging from 1 to 40 can be
set to qualify data entry. This length is defined to be the actual
code length sent (excludes Code ID and trailer/delimiter).
Labels with length exceeds these limits will be rejected. Make
sure that the minimum length setting is no greater than the
maximum length setting, or all the labels of the symbology will
not be read.
2.3.5 UPCA Adjustment
Because UPCA is a subset of EAN13 (with first digit 0), all
UPCA symbols will be treated as EAN13 symbols, if the
UPCA adjustment option is disabled. When UPCA
ADJUSTMENT 1 is selected, the first digit (0) will not be
transmitted when a UPCA bar code is decoded. And when
UPCA ADJUSTMENT 2 is selected, the first 2 digits will not
be transmitted when a UPCA bar code is decoded.
2.3.6 UPCE System Number
There are two kinds of system number for UPCE labels,
system number 0 & system number 1. The transmission of
the system number could be programmable via setup. When
the transmission of the system number is enabled, the
