CIPHER 1022 User Manual
- 16 -
9. Configuring CIPHER 1022
This chapter will show you how to enter configuration mode,
list settings, change settings, and how to exit from
configuration mode.
9.1 Enter Configuration Mode
CIPHER 1022 will be in configuration mode by reading the
"ENTER SETUP" label. And it will activate a L-H-L-H-L-H beep
as an echo.
9.2 List Setting
CIPHER 1022 will transmit the current setting by reading
"LIST" label, and it will activate a L-H beep as an echo. Please
be noted that the firmware version is also included on the first
line of the listing.
9.3 Default Setting
CIPHER 1022 will change all the settings to their default
values when "DEFAULT" label is read.
9.4 Change Settings
1. For most of the settings, only 1 label is needed to complete
the setting, and CIPHER 1022 will activate a L-H beep as
an echo.
2. Modification of the following settings require reading of 2
labels.
•
Code length setting (minimum and maximum)
•
Inter-char delay setting
The first label acts as the OP-CODE which selects the
desired setting, whereas the second acts as the VALUE or
the desired setting. For example, to set the minimum code
length to 5, read the label "MINIMUM CODE LENGTH" first
then read the label "5" in the VALUE LABELS.
In modifying these settings, the followings must be noted,
a. These settings share a common group of VALUE
LABELS for selecting the values, i.e. numbers
ranging from 0 to 250.
b. Instead of a "L-H" beep, after scanning of the first
label, CIPHER 1022 will activate a short beep to
denote an incomplete process.
c. Upon receipt of a valid value, CIPHER 1022 will
activate a "L-H" beep.
