Section III
Operation
006-0006715 10/31/18
Rev J
25 of 44
MPS-MPPS-4000 Guide
www.synqor.com
Power Cable Connections
For safety reasons, the input and output power cables should be connected to the MPS or
MPPS before the source of AC power is turned on, and before the MPS or MPPS is turned on
(see Section I: Warnings and the SET-UP section above). Similarly, one should first turn off
the MPS or MPPS and the source of input power before any power cables are disconnected
from the MPS or MPPS .
ALSO NOTE that when the MPS or MPPS is turned on and delivering power to a load, and then
another piece of equipment is connected to the same output, it is possible that this connection
will momentarily disrupt the quality of the MPS or MPPS’s output voltage.
