17
4. Carefully remove screens from each brew group using a short handled screwdriver and soak
overnight in a similar solution as the portafilters.
5. Rinse screens thoroughly before installing and using. Make sure you install the screens before
brewing any shots of espresso. Failure to do so may plug the drain lines with coffee grounds.
Monthly
1. Check your water filtration system and make sure the cartridges and filters are changed as needed.
In areas of high mineral content, hard water, high particulate count or in very busy locations – the
filtration systems will need to be checked more often.
Quarterly
1. Change portafilter gaskets, closely inspect diffuser screens and filter baskets – change if showing
wear. Call an authorized repair representative to perform routine maintenance.
2.
Please disconnect machine from the power supply;
Check inside the electronics box and gently
remove any build up of dust or debris by using a soft brush and vacuum. It is also important to keep
dust and debris off of your pump motor – this will extend the life of the motor.
Important: Machine service and repair procedures must be performed by authorized
service personnel.
Sabre
™
Machine Specifications
Model 2
Group 3
Group
Voltage 220
220
Hertz
50 / 60
50 / 60
Amps - max draw
28
36
Brew and Steam Specifications:
Watts per Element, Steam Tank
2000 x 2
2500 x 2
Total Steam Element Wattage
4000
5000
Steam Tank Capacity (Liters)
7.7
12.3
Watts per Element, Brew Tank
700 x 2
700 x 3
Brew Tank Capacities (Liters)
1.9 x 2
1.9 x 3
Machine Dimensions:
Inches / mm
Inches / mm
Height (Steam Wand 21", Handle 20.5")
18" / 457
18" / 457
Width (Steam Handle to Handle add 3")
29" / 736
40" / 1016
Depth
23" / 584
23" / 584
Weights & Dimensions:
Lbs / Kgs
Lbs / Kgs
Machine Weight, Empty
154 / 70
190 / 86
Machine Weight, Full of Water
173 / 77
215 / 98
Shipping Weight (approximate)
225 / 103
270 / 123
Boxed Dimensions: L" x W" x H"
41" x 32" x31"
49" x 32" x 31"
Boxed Dimensions: L x W x H m/m
1042x762x787 1245x813x787
Plumbing (Compression)
3/8" OD
3/8" OD
•
CE Compliant (By request)
•
C-Tick Compliant (By request)
IMPORTANT
-
If the voltage on the receptacle used is less than 210 Volts, it may be necessary to install
an In-Line Buck-Boost transformer to increase this voltage.
1 and 2 Group 220 Volt Machines require a 1.0 KVA transformer and 3 Group 220 Volt Machines require a 1.5
KVA transformer.
