4
Important Information
It is important that the installation and servicing instructions throughout this
booklet are followed as any failure to do so may invalidate the warranty of this
appliance.
This appliance must be installed by a qualified Gas Safe Registered engineer. Every
engineer carries a Gas Safe Register ID Card and it is advised you ask to see this
before any work is carried out on installations or converting for use with other gases.
Please pay particular attention to:
Gas Safety Regulations
Health & Safety Law
Local & National Building Regulations
Fire Precautions Act
This appliance is supplied with a one year parts and labour warranty.
Do not use an external in-line Gas Governor to set the pressure, please do so with
the appliances internal gas valves.
This appliance is CE marked declaring the compliance with EC directives. The Gas
Types and Pressures for the destined country are stated on the appliance Data Plate.
The instructions throughout this document are only valid in the countries stated on
the Data Plate
Unless otherwise stated this unit is set for G20 (Natural Gas), however your Gas Safe
engineer MUST confirm the Outlet Pressure is 15mbar before commissioning the unit.
LPG conversion kits are located within your documentation.
Do not remove the Ceramic Blocks from the unit when moving/installing - putting
the blocks back in may damage the thermal paper and block the vortex holes.
There is a metal divider plate in the ceramic bedding – this must not be removed or
the air flow and heat distribution will not work to full effect.
This appliance must be positioned in a draught free position with good ventilation -
cooling air blowing onto the grill can distort the vortex heat distribution.