LFO Rate
Adjusts the rate of the specified LFO.
LFO Init Phase
Adjusts the initial phase of the specified LFO when a
new voice is started. This parameters works just like
oscillator init phase.
5.3.8 Mod Matrix
MM Amount 1-32
The MM Amount destinations allow you to change the
modulation amount of any modulation slot. This fea-
ture can be useful to build complex modulations. For
instance, if LFO 1 modulates the noise level using MM
slot 1, then you could have LFO 2 modulate that slot
by choosing LFO 2 as a source, and MM Amount 1 as
a destination.
Another useful application is to make modulations
dependent on a MIDI controller, e.g. you program a
modulation envelope and wish to have the modulation
depth controllable by the modulation wheel. In that
case you would choose Mod Wheel as a source and the
MM slot(s) containing the modulation envelope as a
destination.
You may also have one MM slot modulate another
MM slot, which in turn modulates another MM slot
etc. For such modulations to work properly, you must
ensure that the MM Amount numbers occur in ascend-
ing order.
5.3.9 FX Bus 1+2
This section describes the effect destinations. Almost
all destinations correspond to their front panel knobs
(refer to chapter 3 for a detailed description of the
parameters), only differences will be explained here.
Dist
Adjusts the corresponding distortion parameters.
EQ 1/2
Since the mid band of the equalizer offers the most
flexibility, its parameters can be modulated by choos-
ing the Freq, Q or Gain parameter, respectively. The
low- and high shelving filters can not be chosen as des-
tinations.
Phaser
Adjusts the corresponding phaser parameters.
68
DUNE 2 User’s Manual
Summary of Contents for DUNE 2
Page 1: ...User s Manual...
