"Q" parameter to control the steepness of the
curve:
Frequency
Magnitude (dB)
0 dB
Q=1
Peak frequency
•
The
Hi Shelf
EQ with a frequency and gain
parameter amplifies or attenuates frequencies
above the chosen frequency.
Frequency
Magnitude (dB)
Cutoff frequency
Amount (+)
Amount (-)
0 dB
4.14.3 EQ 2
This section is identical to EQ 1 and allows further
processing of the signal. For example, two different
frequency regions can be boosted. Another applica-
tion is to move one EQ to the left side of the distor-
tion and one to the right. This allows to control the
sound both pre- and post-distortion, which is useful to
fine-tune the overall timbre.
4.14.4 Phaser
A phaser modifies the phase of the signal around some
frequency, then adds it back to the original signal. The
result is a notch in the frequency spectrum. By vary-
ing the operation frequency periodically with a LFO,
the typical sweeping sound of a phaser is achieved.
Type
The phaser can use between 2 and 12 stages. Each pair
of stages produces one notch in the frequency spec-
trum, so e.g. two stages produce one notch. More
stages result in more notches, which increases the
phasing effect.
Rate + Sync
Sets the modulation rate of the effect in Hertz (Hz).
When the
SYNC
switch is enabled, the rate is speci-
fied in units of the current song tempo, such as quar-
ters, eights or sixteenths notes, with either their stan-
48
DUNE 2 User’s Manual
Summary of Contents for DUNE 2
Page 1: ...User s Manual...
