Symmetricom GoWide 4.6, User Manual

Page: 20 / 134

20
GoWide 4.6 G.shdsl Bridge/Router – User Manual
Installation
097-91022-01 Issue 1: February 2002
S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S
2
Hardware Installation
Figure 3 shows the cable connections to the GoWide 4.6 rear panel. Connecting the
PC to the Ethernet port is described in Procedure A.
Figure 3. GoWide 4.6 Rear Panel Cable Connections
Procedure A. PC Connection to the Ethernet Port
Step Procedure
1 Check that the Ethernet card and the TCP/IP protocol are installed on the PC before beginning installation. (If
the TCP/IP protocol is not installed, go to Appendix A for the installation procedures.)
2 Connect the Ethernet cable from any of the four GoWide 4.6 Ethernet ports to the PC’s NIC card or the
server’s NIC card.
3 Connect one end of the DSL cable to the DSL wall jack and the other end to the “DSL” RJ-11 receptacle on the
back of the GoWide 4.6.
4 Connect one end of the power cord to the wall jack and the other end to the “AC POWER” receptacle on the
GoWide 4.6.
5
Turn on the GoWide 4.6 by placing the ON/OFF switch in the ON position. The Power LED must be a steady
green . The Sync LED will initially be a blinking green. Once the connection is established, the Sync LED will
become a steady green.
End of Procedure
AC POWER
ETHERNET DSL