DOC06501_Revision
F
ATS-6501 Users Guide
65
[format] B
[signal_word] 120
[type] irig
To check the status of the output card use the
status hardware:outputs:slots:N
command
(where N=Card Slot # of the 4387A) to verify the card status.
ATS-6501> settings hardware:outputs:slots:5
[ports]
[1]
[status] good
[2]
[status] good
[3]
[status] good
[4]
[status] good
[power] enabled
[type] 4387A
6.3 Communication
Problems
This section describes some of the errors associated with communications problems and
some potential sources of those issues.
6.3.1 LAN
LAN Connector unplugged.
DHCP
o
When the system is operating press the “Display” button on the front panel. If
the IP Address is set it should switch to those displays and give the local operator
the IP Address. If not, the IP Address was not set it will not display the IP
Address and the unit will assign an IP Address of 0.0.0.0. Plug the LAN
Connector into the rear of the unit and if a DHCP server is available, the unit
should obtain an IP Address.
o
Power cycle the unit.
Static
o
Verify the static IP address Netmask, Broadcast IP, and Gateway were set
properly using the
network
command.
o
If incorrect, Use the
network_config
command to set the correct Mode, IP
address, netmask, broadcast, and gateway.
6.3.2 Console (Command Port)
USB to Serial adapter the improper type (OP 001)
Improper baud rate set on terminal serial port
o
115200,N,8,1, no flow control.
Incorrect serial cable type (requires Null Modem cable.)
6.3.3 External Reference
USB to Serial adapter the improper type (OP002)