Symphonie_Sensor_Connections_Instructions | Rev 2.0 | 23 February 2015 |
|| 1
NRG Sensor Connections to Symphonie
Introduction
These instructions will assist you in connecting standard NRG sensors to a Symphonie logger and also provide
the default slope and offset for each sensor type. These default values are preloaded in the Symphonie logger
(except for iPack voltmeter) and the Symphonie Data Retriever (SDR) software. The values are included here
as a quick reference only - please see the Symphonie manual for logger channel configuration.
Connections
NRG #40
Anemometer
RH-5
Relative Humidity
Sensor
BP-20
Barometric Pressure
Sensor
Li-200SA
Pyranometer
Model 110S
Temperature
Sensor
Rain Gauge
(Novalynx)
Wind Direction Vane
Red Dot
(-) Black
White
(+) Red
NRG #200P
N
White
Logger
Grounding
Wire clamps to
Ground Rod
Ground wire lug
attaches here
Bare shield wire
Bare shield wire
Bare shield wire
White (inner)
White
Red
Black
Bare (outer)
White
Black
Red
Red
White
Black
Black
Ground
Rod
Symphonie wiring panel
Symphonie Sensor Connections
Bare shield wire
Red
Black
Red
White
Black
(+)White
(-)Black
Bare shield wire
Sensor Shield (bare) Wires
Connect to any of the
15 shield terminals
Signal
