562E
6
Rear Panel Overview
Chapter 5
Power Cord - IEC power receptacle. Connect the power cord to an appropriate source of AC
power. Observe the marked power supply voltage on rear panel.
B
ALANCED
/U
NBALANCED
I
NPUT
- 1/4-inch TRS phone
jack. This connector is wired in parallel with the XLR
input connector. Connect either balanced or unbalanced
sources here. Use a tip-sleeve plug for unbalanced
sources and a tip-ring-sleeve (stereo) plug for balanced
sources.
B
ALANCED
I
NPUT
- XLR-3 female connector. This
connector is wired in parallel with the TRS input
connector. Use this connector when you need a
balanced XLR input.
K
EY
I
NPUT
- 1/4-inch tip-ring-sleeve connector, wired tip=return, ring=send and
sleeve=ground. To trigger the expander/gate from an external audio source,
use the tip of this connector to connect the audio signal that you wish to use
as a key signal to trigger the expander/gate. To externally process the
sidechain signal, use the ring of this connector to feed the sidechain signal to
an external processing device, and use the tip as the return from the external
processing device. The wiring diagram for the K
EY
I
NPUT
connector is repro-
duced on the back panel of the 562E.
Note: Remember to set the front panel E
XT
. K
EY
/B
YPASS
/I
N
switch to the E
XT
.
K
EY
position when using the K
EY
I
NPUT
.
B
ALANCED
/U
NBALANCED
O
UTPUT
- 1/4-inch tip-ring-sleeve
(TRS) phone jack, wired tip= high(+), ring =low(-) and
sleeve=ground. Use this jack when you need a 1/4-inch
balanced or unbalanced output. The nominal signal level
here is +4 dBu. The wiring diagram for the B
ALANCED
/
U
NBALANCED
O
UTPU
t connector is reproduced on the back
panel of the 562E. Note: connecting an unbalanced cable
here will result in an output level that is 6dB lower than the
output level you get if you use a balanced cable.
B
ALANCED
O
UTPUT
- XLR-3 male connector, wired Pin
1=ground, Pin 2=high(+) and Pin3=low(-). Use this connector when you need a balanced XLR
output. The nominal signal level here is +4 dBu. The wiring diagram for the B
ALANCED
O
UTPUT
connector is reproduced on the back panel of the 562E.
E
562
WINDOWING EXPANDER/GATE
MANUFACTURED IN LYNNWOOD, WASHINGTON USA
U
AC INPUT
18 WATTS
MAXIMUM
FABRIQUÉ AUX E.-U. PAR SYMETRIX INC., LYNNWOOD, WA USA.
RÉFÉREZ TOUTE RÉPARATION À UN TECHNICIEN QUALIFIÉ.
CHANNEL 1 OUTPUT
BALANCED
BALANCED/
UNBALANCED
KEY
INPUT
SIDECHAIN
CHANNEL 1 INPUT
UNBALANCED
BALANCED/
BALANCED
