The drive rebuild may start the RAID controller automatically, depending on
whether your RAID configuration rebuilds the virtual disk. No disaster recovery
or further action is required.
About replacing more than one disk drive module
Go to the following Symantec Technical Support Web site to obtain instructions
for replacing defective drives:
www.symantec.com/business/support/
Several sets of instructions must be completed if more than one disk drive requires
replacement.
See the Backup Exec 3600 Administrator’s Guide for details.
About replacing the appliance
You cannot open the chassis of the appliance and replace internal components.
If any internal components are faulty you must replace the entire appliance.
Warning:
Any attempt to open the chassis will void your warranty.
Go to the following Symantec Technical Support Web site to obtain instructions
for replacing a defective appliance:
www.symantec.com/business/support/
Several sets of instructions must be completed if an appliance requires
replacement.
See the Backup Exec 3600 Administrator’s Guide for details.
About removing and replacing power supply modules
The Backup Exec 3600 Appliance has two hot-swappable power supply modules.
Fans inside the modules maintain cooling through the chassis. You must make
sure that both modules are connected to separate AC power sources (such as a
wall outlet) and operate properly. If one power supply fails, the other power supply
takes over the full power load and the system runs without interruption. If both
power supply modules fail, or if one fails while you replace the other power supply
module, you must turn off the system immediately. If you do not turn off the
appliance, the system may overheat quickly.
Removing and replacing components
About replacing more than one disk drive module
42
