2.2.Installation Diagram
Step 1: Install Mortice
Step 3: Install Sliding Screw Casing
Step 5: Install Back Panel
Step 2: Install Spindle
Step 4: Connect Front and Back Panel Wires
Step 6: Install Batteries
www.sylvan.co.nz
5
Using drilling
template provided.
IMPORTANT:
If the handle points to the left,
Turn the triangle point to left.
If the handle points to the right,
Turn the triangle point to right.
Adjust upper through bolt
fixing from 55-100mm from
spindle by sliding the screw
casing far from the square
shaft. Depending on the
location of the hole-drilling
or the old door hole..
Slot T-Screw in back face
of lock. When in correct
position, tighten depending
on hole position in door.
Insert the split pin into
the hole and bend it’s
front end to fix to the
square shaft.
