SWM ACE OF SPADES 2018, Operation And Maintenance Manual

Page: 181 / 337

3
1
3
2
3
3
1
2
EN
EN - 49
REMOVING THE REAR WHEEL
(SIX DAYS)
Position the motorcycle in such a way that the rear
wheel is lifted from the ground.
Unscrew the nut (1) of the wheel pin (2) and remove
the latter.
Extract the complete rear wheel, keeping the spac-
ers located at the hub sides.
For refitting, operate in reverse order from removal
fitting the brake disc in the calliper.
- Fit the wheel in the rear fork taking care to cor-
rectly fit the brake disc in the calliper.
- Fit the pin (2).
- Screw on the nut (1) without tightening it.
- Tension the chain using the tensioners (3) as de-
scribed in the relative paragraph.
- Tighten the nut (1) and the nut of the tensioners
(3).
Note*:
Do not operate the rear brake pedal when
the wheel has been removed; this causes the cal-
liper pistons to move outwards.
After removal, lay down the wheel with brake disc
on top.
After reassembly, depress the brake pedal until the
pads are against the brake disc.
REMOVING THE REAR WHEEL (ACE OF SPADES)
Unscrew the nut (1) of the wheel axle (2) and extract
it. It is not necessary to loosen the chain tension-
ers (3); in this way, the chain tension will remain
unchanged after reassembly. Extract the complete
rear wheel, keeping the spacers located at the hub
sides.
To reassemble, reverse the above procedure re-
membering to insert the brake disc into the calliper.
Note*: Do not operate the rear brake pedal when
the wheel has been removed; this causes the cal-
liper pistons to move outwards.
After removal, lay down the wheel with brake disc
on top.
After reassembly, depress the brake pedal until the
pads are against the brake disc.