RE729 Programming Manual to PSWx29 VoX.docx
-
3
-
Specify receiver frequency
Click on the system tab to begin
configuring the pager.
Enter the desired frequency
Leave the profile name blank
For New MMI, select
Loudspeaker for “Loud alert”. In
P1
Enter Addresses
Click on the “Address” tab to
specify the address tones.
Enter Tone 1
Enter Tone 2 (If Tone 1 is a long tone check “L” to grey out Tone 2)
Enter Address name "Mark" (cannot be entered before tone 1 is specified)
Select any
“Grp.”
(address group)
Leave “Priority” unchecked
Select “Type” ToneAndVoice
Select “Voice memory” Dynamic
Select from one of eight Alert patterns (Beep)
Select “Rep.” 4 (alert pattern repetitions)
Leave “P”, “2.” and “CM” unchecked (pause between repetitions and charging unit
alert mask)
Repeat 1-9 for each set of address tones
Setup menus
Click “Options” to set up pager
menus.
