RE729 Programming Manual to PSWx29 VoX.docx
- 14 -
2. (2
nd
tone)
The alert signal continues to be emitted as long as the 2nd tone (or the long tone) is
detected.
CM (Charger Mask)
The Charger Mask (CM) defines the behavior of the pager when in the charging unit. If set
to "Switched OFF" (
CM
, red), the behavior of the pager is the same whether it is in the
charging unit or not.
If set to "Switched ON" mode (
CM
, green), the following behavior options are available:
No:
The pager will not issue alerts for this address when in the charger.
Yes: The pager will issue alerts for this address when in the charger as per
its settings.
Loud: The pager always issues a
LOUD
alert when in the charger even if the
pager is set to
QUIET
.
E (Extension Profile), Classic User Interface only
The user can select between pre-set profiles. In addition to this selection, the extra profile
can be switched ON/OFF at any time.
CH1 (Profiles / CH-Names)
The last columns represent the profiles / channels that were defined in Step 2. The
addresses that are desired may be activated for the frequencies corresponding to these
names.* If a profile is assigned to a frequency which is different from the current
operational frequency, the pager will switch to the new frequency when the profile is
changed (on the pager).** If no profiles are activated (all names are red), a warning will be
displayed prior to writing to the receiver.
* The user may switch between profiles using the pager.
** This applies only to multi channel units.
5.4 Step 4: Define Options Settings
Receiver Type
If you purchased a multi channel pager, select “Scanner”. If you purchased a single
channel pager, select “single channel”.
Net monitoring
This setting is never used in the United States. Always leave it off.
Tone decoder
Bandwidth:
standard value is +/- 0.9%
Timing:
Standard 1s 3s: Suited for most standard 1 second 3 second networks
Standard wide: Suited for networks where wide tolerances are needed
