Swisscom Top S324 ISDN, User Manual

Page: 96 / 126

94
Appendix
Gigaset SX100isdn / englisch / A31008-X150-B102-1-7619 / appendix.fm / 13.10.2003
Appendix
Care
Wipe the base and handset with a damp cloth (use no solvent) or an antistatic cloth.
Never use a dry cloth. This can cause static.
Contact with liquid
If the handset should come into contact with liquid, on no account switch the device
on. Remove all batteries immediately.
Allow the liquid to drain out of the device, and then pat all parts of the device dry.
Keep the handset with the batteries removed in a warm, dry place for at least 72 hours.
In many cases, you will then be able to use it again.
Questions and Answers
If you have any questions about the use of your phone, you can contact us 24/7 at
www.my-siemens.com/customercare. You will find the most frequently asked
questions and answers below.
!
What has happened
when …
Possible cause Possible solution
… the display is blank? The handset is not switched on.
The batteries are flat.
Hold down the End call key
a
for about 2 seconds.
Charge or replace the batteries
(page 9).
… the handset fails to respond
to a key press?
The keypad lock is activated. Press the hash key
R
for
around 2 sec. to deactivate
the lock (page 11).
… "Base x" or Base Search
flashes in the display?
The handset is outside the range
of the base.
The handset is not registered.
The base is not switched on.
Move the handset nearer to the
base.
Register the handset (see
page 9 and see page 81).
Check the power connector at
the base (page 8).
… the handset does not ring? The ringer is switched off.
Internal call forwarding is set to 0
rings (= immediate call
forwarding).
Night service is active.
Activate the ringer of the
handset (page 87).
Increase the number of rings
for the internal call forwarding
(page 70).
Deactivate Night service
(page 58).
… the phone number of the
caller is not displayed even
though CLIP is set?
Calling line identification is
blocked.
The caller must ask his network
provider to enable the
transmission of his number
(CLI).
… the handset does not ring
after setting up the ISDN
phone number (MSN)?
Area prefix (town/city code) was
saved with the MSN.
Save the MSN without the
area prefix (page 65).
… You don't hear anything? The
u
key was pressed – the
microphone has been muted.
Press to return to the call.