•
Then trim the - / negative side leg of the LED down to 12mm long and then solder the black wire
to the - / negative led of the led. Then heat up the heat shrink roughly 4mm before the back of
the LED body for both wires.
•
Now it is time to solder the 220R Resistor to the red lead new the Matrix Twist Socket. Split the
red / black lead roughly 100mm so you can install a resistor to the Red Wire. Cut approximately
a 20mm section out of the Red wire and install the longer piece of heat shrink (40mm) before
soldering the resistor in line.
manual V-05
(5-10-22)
of
8
17
