Step 1 - Prepping Your Shapeways Parts
•
The Body Panel could do with a clear coat to shine it up but is not required - as the one in the
photo on the front page is a raw printed part as is the standard finish for this part from
Shapeways. Though it could get marked by dirty fingers - take care.
•
Note: Light will glow through light colour body panels.
•
The Lens does not require any work so it is ready for parts to be fitted.
•
The Bumper will need the rear hole tapped to either 4mm or to a similar sized imperial thread
though you may need the hole prepped for the correct size.
•
Then to achieve a semi chrome to high chrome finish to the bumper you need to paint the part
with a jet black and then again with a chrome paint preferable in the same brand.
Update photo
manual V-05
(5-10-22)
of
4
17
