31
Q. Swing Beam Hardware
1.
Flip 4'' x 4'' Swing Beam over so that the opposite side of your drilled holes are facing upwards.
2.
Place one (1) Wood Loc Washer on each Carriage Bolt with tangs facing downward.
3.
With a hammer tap bolts through drill holes in Swing Beam until Tangs sink fully into the wood as shown in
(Fig. 21)
.
4.
Flip the 4’’ x 4’’ Swing Beam over so that bolt tips are facing upwards. Apply TIMBER-GLOVE to 4'' x 4''
using the bolt tips as a guide as shown in
(Fig. 21a)
. Tigthly wrap TIMBER-GLOVE around 4’’ x 4’’ Swing
Beam and using the hook and loop strips secure TIMBER-GLOVE in place.
5.
Install (1) 1-1/4'' screw through the Hook and Loop seam every 12’’ along 4'' x 4''.
Note:
Do not sink 1-1/4'' screw head through TIMBER-GLOVE fabric. Doing so can cause TIMBER-GLOVE to
become loose over time. Make the screw heads flush with the surface of the TIMBER-GLOVE.
WOOD LOC
WASHER
Fig. 21
Fig. 21a
4'' CARRIAGE BOLTS
FOR A-FRAME
4-1/2'' CARRIAGE BOLTS
FOR SWING HANGERS
Summary of Contents for Palisade II
Page 51: ...51...
