49
Fig. 3
Loc Nut
Washer
Dipped Chain
Loc Nut
5/16'' Washer
15-5/8'' Outrigger Pin
Push Cap
5-7/8'' Seat Pin
The
O
UTRIGGER
SEAT ASSEMBLY.
1.
Place a rod cap on a hard surface. Insert steel
rod into cap and tap into cap with a hammer.
2.
Insert the seat section into the handle section as
shown in
(Fig. 2)
. Make certain the wedge form
of the seat points towards the center of the unit.
Line up the holes and insert the steel rod through
the holes.
3.
Turn the assembly on its side and support the
cap/rod assembly with a scrap piece of lumber
or dowel and carefully tap a rod cap on the
opposite end using a hammer. Repeat steps for
other seat.
FOOT REST ASSEMBLY.
1.
Place one 5/16'' washer and nut on the rod
assembly
(Fig. 2)
. While holding rod with pliers,
tighten nut until the end of the nut is flush with
black plastic cap (Approx.3 ⁄16").
NOTE:
Do not over tighten, this will cause black
cap to tear.
2.
Insert the footrest section into the body section as
shown in
(Fig. 2)
. Line up the holes and insert
the steel rod through the holes.
3.
Repeat step 1 while holding other end with a
wrench or pliers.
CHAIN ASSEMBLY.
1.
Slip one end of the chain over the eyebolt
(Fig 3)
. Place through the seat.
2.
Place one 1/4'' washer and nut on the eye bolt
assembly
(Fig. 3)
. Tighten nut until the end of the
nut is flush with black plastic cap (approx. 3⁄16").
Repeat for all (4) connections.
NOTE:
Do not over tighten, this will cause black
cap to tear.
3.
Hang the chains from the swing hangers and
crimp the hooks closed with pliers to secure the
chain to the swing hangers.
4.
Place bolt covers over the top of the swing
hangers and loc nuts. Secure to the supports
using two 1-1/4'' screws per bolt cover
(Fig. 1)
.
Fig. 2
Eye Bolt
Bolt Cover
(2) 1-1/4'' screws
Fig. 1
Summary of Contents for Palisade II
Page 51: ...51...
