Remove wall from carton.
NOTE: the UP arrow on
wall.
Determine starting point
as the filter inlet and
outlet holes are at the
beginning of the wall.
Starting at the center of a
bottom plate insert the bottom edge of the wall into
the groove on the bottom rail. Ensure that the
center line of the closure holes in the the wall
align with the
center of the plate
. Make sure that the cutouts for filter inlet and outlet are on the top portion of the wall and
will not be hidden behind a vertical. If the wall ends do not meet, adjust the bottom rail in or out of the bottom
plates. The spacing in all bottom plates should be equal.
10
BOTTOM RAIL AND STRAP LAYOUT
4
Follow the instructions below to properly layout the rail and strap assemblies.
EXAMPLE
OF BASIC
LAYOUT
Patio Block
Bottom Plate
Strap Assembly
45½”
Bottom Rails
Long
Bottom Rail
45½” Bottom Rail
Ground Shield
(Optional)
Transition
Rails
Transition Rails
Transition Rails
Transition
Rails
BOTTOM
RAIL
BOTTOM PLATE
PATIO BLOCK
1/16”
PRE WASHED SAND OR
SIFTED EARTH RECOMMENDED
REQUIREMENT CHART
POOL SIZE
TONS
YARDS
18’ x 12’
2.4 Tons
1.6 Cu.
24’ x 12’
3.3 Tons
2.2 Cu.
24’ x 15’
3.8 Tons
2.5 Cu.
30’ x 15’
4.8 Tons
3.2 Cu.
33’ x 18’
6.0 Tons
4.0 Cu.
39’ x 18’
7.2 Tons
4.8 Cu.
45’ x 18’
8.3 Tons
5.5 Cu.
Mark out pool radius (1/2 pool width) using stakes
"B" as a reference. Form the two end semicircles by
sliding the long bottom rail groove up, into the bottom
plates. Lay out the strap assemblies as shown
removing the stakes as you go. The distance from strap
to strap is 48". Install the 45½” bottom rail in between
each strap as shown. All rails are curved, including the
45½” used on the straight side.
Bring the required amount of sifted earth or pre-
washed sand into the pool area at this time. Refer to
chart on the right for the required
minimum
amount.
Place patio blocks under all bottom plates and end of
strap assemblies.
GROUND SHIELD
AND WALL GUARD
ARE OPTIONAL
Spread a ground shield or plastic
sheeting over prepared ground
(not included). Ground Shield and
Wall Guard are available from your
local pool supply dealer or polyeth-
ylene sheeting can be purchased
from a local hardware supply. This
will protect your pool liner and
metal parts against chemical
reactions from the ground soil.
QUANTITIES NEEDED:
POOL SIZE
18x12 24x12 24x15 30x15 33x18 39x18 45x18
STRAP ASSEMBLIES
2
3
3
4
4
6
7
45½” RAILS
2
4
4
6
6
10
12
LONG RAILS
8
8
8
8
10
10
10
TRANSITION RAILS
4
4
4
4
4
4
4
BOTTOM PLATES
10
10
10
10
12
12
12
48”
INSERT WALL INTO BOTTOM RAILS
5
SKIMMER INLET
4’ x 4’ Plywood
SKIMMER OUTLET
