24
WRAP AROUND PEDESTAL
1 - Insert the logo into the pedestal.
2 - Place the pedestal onto the bottom of the vertical and
align the holes on the side of the wrap with the holes on
the bottom of the vertical. Secure the pedestal using the
#12 x 1/2” screws provided.
1/4”-20 X 3/4”
STAINLESS STEEL
SCREW
#12X1/2” SCREW
1 ON EACH SIDE
#12X1/2” SCREW
1 ON EACH SIDE
OUTSIDE
COVER
1
2
4
1
2
LOGO
If your pool vertical does not have holes, simply use
the cover or the pedestal as a template and drill through
the vertical using a 9/64" diameter drill bit, being careful
not to damage the pool wall.
BUTTRESS TOP COVER
For the Buttress Top cover follow steps
2 and 3 has for the regular Top Covers.
Then insert the #12x1/2” screw trough
the hole in the front cavity of the cover
and tighten securely.
After insert the Logo into the circular
attachment supplied.
Align the circular attachment with the
grove inside the cavity in the front of the
cover and insert the attachment into the
cavity.
TOP
COVER
3
7" XL TWO-PIECE WRAP AROUND COVER AND PEDESTAL
1 - Insert the logo into the cover.
2 - Slide the outside cover into position and align the hole in the cover with the cage
nut attached to the top plate. Secure using the 1/4”-20 x 3/4” screw provided.
3 - Insert the front of the top cover into the hole in the front of the outside cover.
Pull the back of the top cover down until it securely fits under the inside lip
of the ledge. Make sure the bottom lip on the back of the top cover goes
over the back edge of the ledge (Fig. 4).
4 - Align the holes on the side of the bottom wrap with the holes on the top of the
vertical. If the holes are not there or the cover does not reach the holes simply
drill a new set of holes into the vertical. Secure the cover using the #12 x 1/2”
screws provided.
IMPORTANT:
Make sure that the inside edge of the
top cover is securely positioned over the
edge of the ledges
7” XL WRAP
AROUND COVER
