I NSTA LLATIO N
– OPERATING - MAINTENANCE
3
SILVER M
INSTALLATION
– OPERATING - MAINTENANCE
2.
Safety
2.1.
Safety regulations
The climate control unit has been manufactured according to the
latest state of technology and approved safety related regulations.
None-the-less, hazard to life and limb of the user or a third party,
degradation of the equipment and other material assets can arise
due to improper utilisation or utilisation, for which the unit was not
intended.
The unit may be operated only in a technically faultless condition for
its intended purpose, with an awareness towards safety and
potential hazards. Faults, which can diminish operational safety,
must be immediately rectified.
Installation work and commissioning may be carried out exclusively
by trained specialist personnel. The manufacturer's warranty no
longer applies if servicing is not properly carried out.
Fundamental to the warranty is also the completion of a service
contract with a qualified specialist company and its verification by
means of protocol documentation.
The pressure devices built into the equipment are subject to
recurring inspection by a qualified specialist company for air
conditioning technology in accordance with the Industrial safety
regulations (BetrSichV).
The operating Instructions must be read carefully prior to
installation and commissioning by installers, commissioning and
operating personal. Only though adherence to these operating
instructions can mistakes be avoided and fault-free operation be
achieved.
If arbitrary or unauthorised modifications or alterations are
undertaken on the equipment, the manufacturer's warranty is no
longer valid.
The equipment is part of an air conditioning system and may be
operated only after installation of the entire system.
2.2.
Markings and their use
This symbol indicates an immediate danger. Failure to follow these
instructions can result in injury to persons or damage to the
equipment.
"Environmental symbol" identifies the points, which could result in a
charge for the environmental pollution.
2.3.
Safety instructions
In order to avoid overheating damage to the system, the steam heat
exchanger should be operated only with the ventilator running.
When using the temperature limiter, it must be observed that the
temperature monitor is adjusted ca. 5K lower than the safety
temperature limiter.
The allowable pressure level for the heat exchanger and associated
piping may not be exceeded.
Accessibility to safety relevant components must be guaranteed
over the entire serviceable life.
The electrical connection, as well as the servicing of electrical
components, may be carried out only by an electrician specialist.
The stipulations of VDE 100/DIN 57100 are especially applicable.
In conjunction with the initial connection and subsequent
inspections, the electrical connection bolts must be re-tightened.
Special regulations, such as building oversight guidelines for fire
protection regulations related to air conditioning systems, are
compulsorily prescribed and, for this reason, must absolutely be
adhered to.
Refrigerant (odourless and tasteless) suppresses atmospheric
oxygen and can lead to asphyxiation. In the event of a refrigerant
leak, the machine room should be accessed only with heavy duty
breathing protection equipment.
When disposing of refrigerant, environmental protection
regulations should be observed.
When the equipment is functioning in an explosion hazard
atmosphere, please observe Chapter 8!
