SVP UDT-02, Manual

Page: 95 / 165

UDT-02 UHD HEVC Digital Camera Transmitter
MANUAL V1.0
95
N43º02.032’
W023º03.023’
•
Status (reading parameter):
The status of the GPS input is displayed in this field.
• Latitude (reading parameter):
It specifies the latitude position of the transmitter.
•
Longitude (reading parameter):
It specifies the longitude position of the transmitter.
•
Altitude (reading parameter):
The height of the transmitter from ground in meters is specified in this
value.
•
Direction (reading parameter):
The direction in degrees of the transmitter is shown in this field.
•
Speed (reading parameter):
The speed of the transmitter in km/h is shown in this field.
6.2.1.20 KLV Metadata (Optional)
When this option is ON, the KLV Metadata embedded on the SDI signal is sent
through the radio link.
6.2.1.21 Encoder output
• TS Bitrate Auto (eligible parameter):
The bitrate mode can be automatic or manual. In case automatic mode
is selected, the device configures automatically the video bitrate
depending on the modulation, FEC, IG, BW used, in order to the video
bitrate can be always the maximum allowed. SVP advises the use of
the automatic mode when the signal is transmitted through RF. Manual
mode is useful when the device is used as an encoder to configure the
desired output bitrate in the ASI output.
•
TS Bitrate Manual (editable parameter):
If the bitrate mode is manual, select the bitrate.
6.2.1.22 TS Parameters
•
Video PID (editable parameter):
Here the video packet identifier must be entered.