Sven ROYAL 1R, Operation Manual

Page: 21 / 24

• If the remote control doesn’t work, check the batteries or
replace the discharged batteries with new ones.
• Remove the batteries from the remote control if the
system is left unused for a long period of time (more than a
week).
• Keep the remote control in a clean, dry place.
8. INSTALLATION AND OPERATION GUIDE
ROYAL 1R Multimedia Speaker System can be connected to
virtually any audio source: DVD/CD, PC, laptop, etc. (see con-
nection diagram, Fig. 4).
•
Before making any connections, make sure that the MSS is
switched o Ԛ . Connect the speakers to each other using the
audio cable (included). To do this, unscrew the binding posts on
the passive speaker, insert the positive (red) cable end into the
hole of the positive binding post, and the negative (white) cable
end into the hole of the negative binding post, as shown in Fig. 4,
and then connect the cable to SPEAKER R
g
on the active
speaker in the same way. Screw up the binding posts tight.
Notes:
• Always match the polarity.
• Do not short the speaker cable ends together.
• After connecting, all the binding posts must be tightened
well.
•
To connect the MSS to a TV or DVD/CD player, plug the RCA
jacks of the 2RCA to 2RCA stereo signal cable (included) to AUX
AUDIO INPUT R/L
f
of the active speaker, and connect the other
RCA jacks of the signal cable to the output of the TV, DVD/CD
players, as shown in Fig. 4.
• To connect the MSS to a PC, MP3/CD player, plug the RCA jacks of the 2RCA to mini-jack Ø 3,5
mm (included) stereo signal cable into the DŽDž AUDIO INPUT of the active speaker
f
, and connect
the mini-jack of the signal cable to the output of the computer sound card or to the audio output (Ø
3.5 mm jack) of another sound source, as shown in Fig. 4.
Note.
Sound quality is directly affected by correctness and reliability of the connection of
cables. The left RCA jacks should be inserted into the left ports of the ampli Н er (usually
white), and the right RCA jacks should be inserted into the right ports of the ampli Н er
(usually red). It is recommended that cables included into the package contents of the
MSS be used.
•
Adjust the volume to its minimum using the VOL-
d
button on the control panel or control button
VOLUME-
g
on the remote control, then connect the MSS to the mains outlet via the built-in power
cable
j
.
•
Switch on the MSS by shifting the POWER switch
h
into the ON position, and the power LED
a
on the front panel will illuminate. Then, using the INPUT AUX/PC
d
buttons on the remote control,
choose the system input.
Fig. 3. Remote control
a
c
b
e
g
d
INPUT
REMOTE CONTROL
AUX PC ST-BY
MUTE TRE+ BASS+
RESET
VOLUME
+ –
TRE– BASS
–
f
ENG
20
2.0 Multimedia Speaker System