GX301
14
SVAT ELECTRONICS
now you can see
INSTALLATION
To connect IR extension:
1. Plug the jack of the IR extension cord into the IR extension
input on the back of your receiver.
2. Peel the paper off the two sided tape on the other end of
the IR extension cord.
3. Place the sticky end of the IR extension cord to an area that
will receive the best signal from the remote control.
IR EXTENSION
The GX301 comes equipped with an IR extension. This IR extension is for the remote control, it allows for a better
signal between the remote and receiver.
Plug IR extension in
To pair a camera and receiver:
1. On the receiver, press the menu button.
2. Using the arrow buttons, scroll to “Pairing” and
press OK.
3. A list of camera channels will appear numbered
Camera 1 – Camera 4. If you purchased additional
cameras or if your kit came with additional
cameras, you must use a different channel for each
camera.
4. Select the camera channel you would like to pair
your camera to and press OK.
5. A screen will appear counting back from 30
seconds.
6. Within that 30 seconds, use a pin or small
screwdriver to press the pairing button on the back
of the camera that you are pairing to the receiver.
7. The camera and receiver will then pair and you will
see the camera’s view appear on screen.
8. If you purchased additional cameras or your kit
came with additional cameras repeat the above
pairing steps using different camera channels for
each additional camera.
Pairing the camera and receiver will be necessary if the camera and receiver do not automatically pair or if you
purchased a kit with additional cameras. A small pen or screwdriver is necessary to press the camera’s pair button.
Select Camera
30 Seconds to pair
Press pair button
PAIRING
