COOLING AND LUBRICATION SYSTEM 6-9
COOLING FAN THERMO-SWITCH
REMOVAL
• Remove the front fender. (
#
7-6)
• Drain a small amount of engine coolant. (
#
6-4)
• Disconnect the cooling fan thermo-switch lead wire coupler
1
.
• Remove the cooling fan thermo-switch
2
.
INSPECTION
• Check the thermo-switch closing or opening temperatures by
testing it at the bench as shown in the figure. Connect the
thermo-switch
1
to a circuit tester and place it in the oil con-
tained in a pan, which is placed on a stove.
• Heat the oil to raise its temperature slowly and read the col-
umn thermometer
2
when the switch closes or opens.
&
09900-25008: Multi circuit tester set
'
Tester knob indication: Continuity test (
(
)
$
Cooling fan thermo-switch operating temperature
Standard (OFF
→
→
→
→
ON): Approx. 88°C (190°F)
(ON
→
→
→
→
OFF): Approx. 82°C (180°F)
!
INSTALLATION
• Install the new O-ring
1
.
• Tighten the cooling fan thermo-switch to the specified torque.
%
Cooling fan thermo-switch: 30 N·m (3.0 kgf-m, 21.5 lb-ft)
• Pour engine coolant. (
#
2-12)
• Install the front fender.
Oil
* Take special care when handling the thermo-switch.
It may cause damage if it gets a sharp impact.
* Do not contact the cooling fan thermo-switch
1
and
the column thermometer
2
with a pan.
Summary of Contents for LT-F500F 2002
