PERIODIC MAINTENANCE 2-11
FUEL LINE
• Remove the seat.
• Remove the fuel tank mounting bolts. (
!
4-3)
• Lift up the fuel tank.
Inspect the fuel hoses
1
for damage and fuel leakage. If any
defects are found, the fuel hoses must be replaced.
ENGINE IDLE SPEED
NOTE:
Make this adjustment when the engine is hot.
• Start the engine, turn the throttle stop screw
1
and set the
engine idle speed between 1 100 and 1 300 r/min.
"
Engine idle speed: 1 200 ± 100 r/min
THROTTLE CABLE PLAY
Adjust the throttle cable play
A
as follows.
• Loosen the locknut
1
of the throttle pulling cable
2
.
• Turn the adjuster
3
in or out until the throttle cable play (at
the throttle grip)
A
is between 2 – 4 mm.
• Tighten the locknut
1
while holding the adjuster
3
.
"
Throttle cable play
A
: 2 – 4 mm
'
NOTE:
Major adjustment can be made at the carburetor side adjusters.
(
!
4-24)
Inspect every 6 000 km (12 months).
Inspect initially at 1 000 km (2 month) and every 6 000
km (12 months) thereafter.
Inspect initially at 1 000 km (2 month) and every 6 000
km (12 months) thereafter.
After the adjustment is completed, check that handle-
bar movement does not raise the engine idle speed
and that the throttle grip returns smoothly and auto-
matically.
Summary of Contents for GSF650
