5-48 CHASSIS
• Tighten the brake caliper mounting bolts to the specified
torque.
#
Brake caliper mounting bolt: 39 N·m (3.9 kgf-m)
)
BRAKE FLUID REPLACEMENT
• Place the motorcycle on a level surface and keep the handle-
bars straight.
• Remove the brake fluid reservoir cap and diaphragm.
• Suck up the old brake fluid as much as possible.
• Fill the reservoir with new brake fluid.
-
Specification and classification: DOT 4
• Connect a clear hose to the air bleeder valve and insert the
other end of the hose into a receptacle.
• Loosen the air bleeder valve and pump the brake lever until
the old brake fluid flows out of the brake system.
• Close the air bleeder valve and disconnect the clear hose. Fill
the reservoir with new brake fluid to the upper line of the res-
ervoir.
$
#
Brake air bleeder valve: 8 N·m (0.8 kgf-m)
After remounting the brake calipers, pump the brake
lever until the pistons push the pads correctly.
Bleed air from the brake system. (
!
2-17)
Summary of Contents for GSF650
