Suzuki GSF650, Service Manual

Page: 202 / 333

5-40 CHASSIS
CUSHION LEVER AND CUSHION RODS
Inspect the cushion lever and cushion rods for damage.
SWINGARM PIVOT SHAFT
Measure the swingarm pivot shaft runout using the dial gauge. If
the runout exceeds the service limit, replace the pivot shaft.
%
09900-20606: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
09900-21304: V-block set (100 mm)
&
Swingarm pivot shaft runout
Service Limit: 0.3 mm
REAR SHOCK ABSORBER
Inspect the rear shock absorber for damage and oil leakage. If
any defects are found, replace the rear shock absorber with a
new one.
$
REASSEMBLY
SWINGARM BEARINGS
• Before installing the swingarm pivot bearings, make sure to
insert the spacer between them.
• Press needle bearings into the swingarm pivot using the spe-
cial tool.
NOTE:
Install the needle bearings with the stamped mark facing out.
%
09941-34513: Steering outer race installer
• Apply grease to the spacers, dust seals and needle bearings.
'
99000-25010: SUZUKI SUPER GREASE “A”
Do not attempt to disassemble the rear shock
absorber. It is unserviceable.