68
Adjusting Trolling Speed
• When pressing the “UP” switch, one short
beep sounds and the engine speed
increases by 50 r/min.
• When pressing the “DN” switch, one short
beep sounds and the engine speed
decreases by 50 r/min.
NOTE:
Shift operation and throttle control remain oper-
ational, even in troll mode.
Cancelling the Troll mode:
The troll mode can be cancelled by shifting the
all remote control levers to the neutral position,
or by increasing the engine speed to 3000 r/min
or more. In both cases, two short beeps sound
when cancelling the troll mode.
OPERATION IN SALT WATER
After operating the motor in salt water, you
should flush the water passages with clean,
fresh water as outlined in the FLUSHING THE
WATER PASSAGES section. If you do not flush
the water passages, salt can corrode the motor
and shorten its life.
OPERATION IN FREEZING WEATHER
When operating your outboard motor in freez-
ing temperatures, you should keep the lower
unit submerged in the water at all times.
When taking motor out of the water, stand it up
in a vertical position until the cooling system
drains completely.
NOTICE
If you leave your outboard motor out of the
water in freezing temperatures with water still
in the cooling system, the water can freeze
and expand, causing severe damage to the
motor.
When your outboard is in the water in freezing
temperatures, keep the lower unit submerged
in the water at all times. When the motor is
stored out of the water in freezing tempera-
tures stand it up in the vertical position so
that the cooling system drains completely.
MOTOR REMOVAL AND
TRANSPORTING
MOTOR REMOVAL
If it is necessary to remove the outboard motor
from your boat, we recommend that you ask
your authorized Suzuki Marine Dealer to do the
work for you.
MOTOR TRANSPORTING
When transporting the motor, place the motor
either vertically or horizontally.
Vertical transport:
Attach the motor to the carrier by securing
clamp bracket with two sets of transom bolt and
nut.
Never use display stand for transportation of the
motor.
Horizontal transport:
1. Drain the engine oil. Refer to the ENGINE
OIL section.
2. Drain the gasoline from the vapor separator
1
as follows:
(1) Remove the motor cover.