48
If not equipped with Keyless Start System:
NOTE:
If equipped with Keyless Start System:
The PTT switch on the remote control lever
cannot be activated when the keyless start sys-
tem is in OFF state.
If not equipped with Keyless Start System:
The PTT switch on the remote control lever can
not be activated when the ignition key is off.
NOTE:
Repeated operation of the power trim and tilt
(PTT) causes the overheating of the PTT motor
and the protection circuit may stop the opera-
tion of the motor. While the protection circuit
activated, the PTT switch is inoperative. This
inoperative condition of the system is cancelled
once the overheating is resolved.
8
WARNING
The power trim and tilt (PTT) switch on the
side cover can be accidentally activated when
the ignition key is off, resulting in injury.
Keep all persons away from the outboard
motor to help prevent accidental activation of
the PTT system.
TILT LIMITER CAM
If the outboard motor contacts the motor well of
the boat while tilting, adjust the tilt limiter cam to
limit maximum tilt position.
1. Place the motor in the normal running posi-
tion.
2. Rotate the tilt limiter cam:
To reduce the amount of tilt, move the tab
A
of cam upward.
To increase the amount of tilt, move the tab
A
of cam downward.
3. To check your adjustment, tilt the motor fully
up to check for motor contact.
Adjust further if necessary.
Return the motor to the normal running posi-
tion for each adjustment, and repeat your
check after each adjustment.
8
WARNING
Adjusting the tilt limiter cam will not prevent
the outboard motor from tilting fully up and
contacting the motor well if the motor’s lower
unit hits an object at high speed. Such tilting
could damage your motor and boat and injure
boat occupants.
Keep all occupants away from the motor when
operating at high speed.
