3-44 ENGINE
STARTER TORQUE LIMITER
INSPECTION
• Measure the torque when slipping by means of the special
tool and torque wrench.
• If the measurement result is out of standard value, replace the
starter torque limiter with a new one.
Slip torque
standard: 22 – 41 N·m (2.2 – 4.1 kgf-m, 16 – 29.5 lb-ft)
[
09930-73170: Starter torque limiter holder
09930-73120: Starter torque limiter socket
OIL PUMP
INSPECTION
• Rotate the oil pump by hand and check that it moves
smoothly.
• If it does not move smoothly, replace the oil pump assembly.
OIL PRESSURE REGULATOR/OIL SUMP
FILTER
• Inspect the operation of the oil pressure regulator by pushing
on the piston with a proper bar.
• If the piston dose not operate, replace the oil pressure regula-
tor with a new one.
• Check the oil sump filter for clogging and damage.
• If any fault is detected, clean or replace with new one.
* Do not attempt to disassemble the oil pump assem-
bly.
* The oil pump is available only as an assembly.
Summary of Contents for AN650 2002
