ELECTRICAL SYSTEM 10-37
BATTERY
SPECIFICATIONS
a
Anode plates
e
Stopper
b
Separator (fiberglass plate)
f
Filter
c
Cathode plates
g
Terminal
d
Upper cover breather
h
Safty valve
INITIAL CHARGING
FILLING ELECTROLYTE
• Remove the aluminum tape
1
which seals the battery filler
holes
2
.
• Remove the caps
3
from the electrolyte container.
NOTE:
* Do not remove or pierce the sealed areas
4
of the electrolyte
container.
* After completely filling the battery with electrolyte, use the caps
3
from the electrolyte container to seal the battery filler holes.
• Insert the nozzles of the electrolyte container
5
into the elec-
trolyte filler holes of the battery. Hold the electrolyte container
firmly so that it does not fall. Do not allow any of the electro-
lyte to spill.
• Make sure the air bubbles
1
rise to the top of each electrolyte
container and leave the electrolyte container in this position
for more than 20 minutes.
Type designation
FTX14-BS
Capacity
12V, 43.2 kC (12 Ah)/10HR
Summary of Contents for AN650 2002
