ELECTRICAL SYSTEM 10-11
STARTER SYSTEM
TROUBLESHOOTING
Starter
motor
Stater
relay
Starter button
Rear brake switch
Front brake switch
Engine
stop
switch
Fuse
Fuse
Ignition
switch
Battery
Side-stand
switch
To ignition
coil/plug cap
Side-stand relay
Starter motor will not run.
Grasp the front or rear brake lever, turn on the
ignition switch with the engine stop switch in
the “RUN” position and side-stand switch in the
“ON” position. Listen for a click from the starter
relay when the starter button is pushed.
Check if the starter motor runs
when its terminal is connected
to the
+
battery terminal (Do
not use a thin wire because a
large amount of current flows.)
Make sure the fuses are not blown
and the battery is fully-charged
before diagnosing.
Measure the starter relay voltage at the starter
relay connectors (between Y/G
+
and Y/B
-
)
when the starter button is pushed.
No click
Clicks
Runs
Voltage
No voltage
• Faulty starter relay
• Loose or disconnected starter
motor lead wire
• Faulty ignition switch
• Faulty engine stop switch
• Faulty side-stand relay
• Faulty front brake switch
• Faulty rear brake switch
• Faulty starter button
• Improper connector contact
• Open circuit in wire harness
Continued on next page
• Faulty starter motor
Does not run
Summary of Contents for AN650 2002
