Installation Procedure
1. Plan the final position of the roundabout ensuring there is enough space*. The roundabout can only be
installed on a level site, maximum gradient 1 in 50**.
2. Excavate the foundation according to the drawings. It's important that water does not
collect beneath the roundabout, so additional drainage may be required if the ground is not free
draining.
3. The roundabout parts are very heavy, lifting equipment will be required.
4. The roundabout is supplied with the top assembly fitted to the base ring. These should be carefully
separated by lifting the top assembly away from the base ring, keeping both parts horizontal to
prevent distortion.
5. Lift the base ring into the foundation hole. It's important that the base ring remains perfectly round so
do not rest it on its side and ensure it is supported all round when in the foundation hole. When installed
ensure the base ring is level in all directions
6.Fasten the lower outer rings and the upper outer rings to the base ring using the supplied M10 bolts, nuts
and washers. Ensure the lower rings are fastned tight, leave upper rings loose for ajustment later. The top
of the upper rings should be at play level.
7. Install the concrete foundation around the outside lower ring 200mm deep, this should bring the concrete
to just under the upper rings.
8. Install the lower part of the centre pole. It's important that this is vertical, exactly in the centre of the ring,
and the top surface is level with the top of the upper outer rings.
9. Do not install safety surfacing until the top assembly has been installed in case adjustment is needed.
10. When the concrete has set (2 to 3 days) the top assembly can be lowered onto the base ring. Ensure
that both the vertical and horizontal faces of the track ring are free from debris and there is sufficient clear-
ance for the guide wheels. Take care when lowering the top assembly that it is central to prevent damage
to the four guide wheels.
Description
Qty.
Code Ref
Base
Ring
1
SWD052GAL
Top
Assembly
1
SWD062
Centre
Pole
Assembly
1
SWD076
Lower
Outer
Ring
4
SWD078GAL
Upper
Outer
Ring
4
SWD079GAL
SWD050 Inclusive Roundabout
Installation Instructions
Tape Measure
Spirit Level
Digging Implements
Wrench 17mm
Set of Allen Keys
Lifting equipment
Security tool FIX195
Parts List
Sheet 2 of 6 Rev 01
ve Roundabout
ctions
v 01
SWD062
SWD052GAL
SWD076
SWD076
Required Tools
SWD078GAL
SWD079GAL
