Installation Procedure
11. Ensure the roundabout rotates freely. The gap between the edge of the inner ring to the outer rings should
be no more than 8mm but must also not touch. Tighten the bolts securing the top outer rings.
12. If the roundabout is not rotatig freely, follow the adjustment instructios attached.
13. Fit the top part of the centre pole using the four M12 countersunk screws. Use the additional packing
washers provided between the joint if required to ensure the centre pole lower plate does not rub on the deck.
14. Do not allow the roundabout to be used until the required safety surfacing has been installed.
Follow the maintenance instructions supplied.
* Care should be taken while installing to decrease the hazard for children.
** Care should be taken if the conditions aren’t normal.
SWD050 Inclusive Roundabout
Installation Instructions
Sheet 3 of 6 Rev 01
Safety Surfacing
Area 28.5m2
Perimeter 20.5m
HIC 1m
This product is not suitable for
installation into loose fill surfaces.
